Design Master Wish List
Welcome to the Design Master Wish List, where you can submit your ideas for improvements to the software.
368 results found
-
Swap & Copy Circuits
When copying circuits in the swap and copy dialog, multipole breakers do not copy to the new location as multipole breakers, they copy as single pole. It appears that you have to set the number of poles and their positions in the circuiting dialog before starting the copy/swap routine.
30 votes -
Select automatic conduit based on Type
When selecting conduit I want to be able to select the feeder as schedule 80 so that the only size option would be based on schedule 80. Then on another feeder I could select EMT for my circuits and the only option for auto sizing would be based on EMT. Finally, I would then have the option of adding the type to my one-lines and a conduit schedule.
11 votes -
Show conduit runs with schedules
Be able to show conduits feeder runs on their own layer with up and down riser symbols. Then be able to create a conduit schedule.
4 votes -
Update Pipe Breaks on Save or Open
When inserting fittings or piping the software will go through a regeneration process after each item is inserted. When files are small this is not a big deal. On large projects there is a noticeable delay and the software zooms out to the extents and then back into the area you are working on. Rather than do this on every change, include an option to only do this when the drawing is saved (and possibly when the drawing is opened).
5 votes -
Draw Circuit Loops Using Polylines instead of Arcs
When you loop from one device to another, be able to select that loop and break it in to two loops that can each individually be moved or broke. This way we can have "S" loops.
DM Note: When we implement this, it will probably be by allowing you to insert a loop using a pline. This will allow you to insert the loop however you want without any restrictions.
20 votes -
Copy and Increment Across Drawings
Improve the "Copy and Increment" command to work across drawings. Make it easier to move everything from one panel to a different panel on the copied devices.
4 votes -
VAV Box Schedule
Create a schedule of VAV boxes, similar to the diffuser schedule.
38 votes -
Set Room Exhaust Rate
Specify the exhaust air requirements for rooms and use these numbers in the load calculations and duct design calculations.
27 votes
- Don't see your idea?