chris partrich
My feedback
22 results found
-
10 voteschris partrich
supported this idea
·
-
11 voteschris partrich
supported this idea
·
-
12 voteschris partrich
supported this idea
·
-
77 voteschris partrich
supported this idea
·
An error occurred while saving the comment -
3 voteschris partrich
supported this idea
·
-
3 voteschris partrich
supported this idea
·
-
10 voteschris partrich
supported this idea
·
-
6 voteschris partrich
supported this idea
·
-
4 voteschris partrich
supported this idea
·
-
3 votes
This request wouldn't be hard, but it is one we've specifically avoided to this point. Our thinking is that the AIC rating of a panel is an important enough setting that we want it reviewed and set intentionally by the engineer.
chris partrich
supported this idea
·
-
12 voteschris partrich
supported this idea
·
-
16 voteschris partrich
supported this idea
·
-
2 voteschris partrich
supported this idea
·
-
45 voteschris partrich
supported this idea
·
-
6 votes
An error occurred while saving the comment chris partrich
commented
Would also like to see the automatic upsizing of branch circuits be able to be based on voltage drop instead of distance (in options it is "upsize #12 to #10 option). If that is not possible then have two settings, one for 120V branch circuits and one for 277V branch circuits. Right now if we have this this option set to "yes" and a distance of 100' input the software does not distinguish between 120V and 277V circuits and unnecessarily upsizes the lighting circuits to #10.
-
8 voteschris partrich
supported this idea
·
-
118 voteschris partrich
supported this idea
·
-
19 voteschris partrich
supported this idea
·
-
56 voteschris partrich
supported this idea
·
-
29 voteschris partrich
supported this idea
·
Voltage drop upsizing is preferred, but If for some reason you are unable to upsize based on voltage drop, at a minimum you could add some flexibility to wire size options to allow lengths for upsizing from #12 to #10 to be voltage-specific. Right now if I enter 100' DM does not differentiate between 120V and 277V circuits and lightly loaded 277V circuits end up being unnecessarily upsized.