Design Master Wish List
Welcome to the Design Master Wish List, where you can submit your ideas for improvements to the software.
191 results found
-
Number Circuits Sequentially in Panels
Allow panels to have the circuits in them numbered sequentially, rather than split odd and even.
1 vote -
1 vote
-
Display Equipment Disconnect Ratings on Drawing
Display the rating of the disconnect and the rating of the fused on the drawing adjacent to the disconnect symbol.
1 vote -
Add an attribute for panel schedule
Add an attribute that adds the odd circuit and the even circuit in a panel schedule, i.e. circuits 1 & 2, circuits 3 & 4, etc., and be able to put that attribute in the phase block of the panel schedule.
1 vote -
Fault in Equipment Schedule
Add a column to the equipment schedule to show the available fault.
Currently equipment fault can only be seen in the full fault schedule for the entire project.
0 votes -
Update the Excel Add-in to work in Recent Version of Excel
The Excel Add-in is two pieces: functions in Excel for pulling information from the DM database, and a set of pulldown menus and dialog boxes for inserting these functions.
The functions still work and can be used manually.
The pulldown menus and dialog boxes no longer work in newer versions of Excel.
This wish list item is for us to fix the menus and dialog boxes to work again.
0 votes -
Arc-Flash Stickers based on NEC 110.16(B)
Create arc-flash stickers based on NEC 110.16(B). These stickers are much simpler than what are required by NFPA 70E.
0 votes -
Load by Phase in "Circuiting" Dialog Box
Display the phase that loads are on in the dialog box to make balancing panels easier.
0 votes -
Homerun Wire Callout Option
Add an option for homerun callouts to not display anything for #12 wires and to display tick marks and the full wire callout for anything else.
Currently there are a few options that are close but nothing that has exactly these groupings of tick marks and wire callouts.
0 votes -
Set default "Feeder length calculation method" to "Custom"
Be able to set the default "Feeder length calculation method" to "Custom".
0 votes -
Change default panel "Mounting"
Be able to set a different default value for the "Mounting" setting for panels and other distribution equipment.
0 votes
- Don't see your idea?